The following lists he parts needed to assemble the printed cicuit boards associated with a Milton VC Seqeuncer. Because your configuration may vary, I did NOT include parts required for operation which will be faceplate mounted. These parts include: Knobs (16 per bank) Faceplate Jacks Mommentary buttons (2) for Start/Stop Single pole ON-OFF-ON toggles for Programmable Pulse Banks (16) Double Pole, Single Throw toggle for CV mode select (1) Single Pole, Single Throw toggle for Programmable Pulse Enable (1) Stage LEDs (16) Start/Stop LEDs (2) I have also omitted the 16 pin DIP header cables which will be needed to connect these boards together. One is required from the main engine board to the first bank board, and one each is required for each addition bank.